'91 JDM 6 bolt engine with approx. 90k.

NEW valve cover gasket, fresh powder coated valve cover (satin red) with polished letters and stainless fasteners
NEW pcv valve
NEW evo oil cap
NEW spark plugs
MSD 8mm spark plug wires
510cc injectors, NEW seals
NEW Magnus heat barrier intake manifold gasket
NEW throttle body gaskets
NEW gates timing belt/water pump kit, NEW tensioner
NEW STM balance shaft elimination kit installed
NEW oil pan gasket,NEW K&N oil filter
NEW knock sensor
NEW O2 sensor
NEW coolant temp sensor
NEW thermostat and gasket
pace setter exhaust manifold, NEW wrap
NEW 4 layer exhaust manifold gasket, studs and nuts
small 16g turbo ZERO shaft play
O2 housing in excellent shape, no cracks
stainless oil feed line with NEW crush washers
NEW alternator, NEW belt
NEW power steering belt
-10an stainless oil return line and fittings
aluminum crank pully

As you can see from the pics it is very clean.
THE J-PIPE AND THROTTLE BODY ELBOW ARE NOT INCLUDED.

$1800.00 negotiable
PM ONLY
















Thanks.

Like I said the price is negotiable. If the engine sells than there will be a mass of 1g performance parts to follow.

I also have a cyclone intake that I will include. I cleaned it up a bit. It's just the bare manifold but the butterflies are in.

$1600.

Open to offers.

Check mail

To clarify with everyone who has pm'd me. I'm not going to strip it or part it out. It's all or nothing.

Thanks

I'll throw in a BNIB AWD ACT flywheel and a ACT 2100 clutch that has maybe 8k on it. I payed over $300 for the flywheel alone. $1600.00 for everything.

To answer the pm's all at once. YES, I will sell the flywheel by itself. $1600.00 and I'll throw in a engine and a clutch.

I'm buying a car so I'll take a loss on this to get rid of it. $1300. with the flywheel and clutch.

PM only

I bought a car. I want to move this and a mass amount of other 1G performance parts. Engine must sell first. Make a serious offer.

Thanks

Still have this. I have a full injen polished 2g intake setup with pig tail for both 1g or 2g. New rad with slim fans and New mishimoto hoses. Massive kinetic FMIC with full 2.5" stainless piping. Lots of other parts as well once the engine sells.