I didnt want to clutter the pics thread with all this stuff so here it is.
Sleeping for winter, I did plan On storing it but that didn't work out this year so it mostly sat around:
Link
Link

First pics of Cf hood and clear corners, left pin not yet installed:
Link
It looks just like paint in certain light:
Link
Link

Gauge install:
Link
Link
Oil pressure Hookup:
Link
If you look closely at the rubber EPDM hose you can see where I routed the copper tube:
Link
Link
The oil pressure gauge that exploded:
Link
Im Going to keep the copper tubing and use it to remote mount the sender just before the strut tower.
Almost finished, replacement electric oil guage,Just need a fitting and a Fuse:
Link
Link
Link

Jaime Loo Exhaust:
Link
Link
Link
Link
Link
Link
Link
It came close/rubbed the driveshaft and that had to be fixed:
Link
This hangar(on car) had to be unbolted and turned around:
Link
This hangar(on exhaust) had to be bent to clear suspension parts:Link
I think it looked pretty good actually:
Link
Link
Link
Link

Now it has the magnaflow muffler and cat:
It sags a little and I plan on fixing that, also they pissed me off because the tips should not have been the same length
Link
Link
Link
Link
Link

The Bent wheels:
Bent Wheel Front:
Link
Link
Link
Back:
Link

GSX and 3G rims From Mike Degli Angeli:
GSX:
Link
Link
3g:
Link
Link
All 4 unbent GSX rims Are being powdercoated, and the 2 3Gs and the 2 bent ones are on the car temporarily. Heres what a Deeper Dish/staggered offset looks like on back of car:
Link
Link
I wish I could keep It that way but Rotating tires would cost too much, unless the whole wheel was moved to the front which would just look dumb IMO

New Pirellis from Fai smile :
Link
Link
Link

Last edited by Jeff Mitchell; May 08, 2009 12:42 pm UTC.
98GSX Black:1st car/resto proj
97 acura el stolen/found
99GSX Red
RIP 86 turbo ZX, 92 turbo 2000GTX